TP304L BA grade stainless steel pipe 304 stainless steel pipe High pressure resistant steel pipe 1/2 inch 1m

TP304L BA grade stainless steel pipe , 304 stainless steel pipe High pressure resistant steel pipe 1/2 inch 1m

Calculate: Air consumption.

Solution: Select the given piston diameter, determine the intersection of the horizontal line and the operating pressure line, and the air consumption can be read from the horizontal axis. Multiply the read value by the stroke (cm) of the pneumatic cylinder. The value read in the above steps is 0.091/cm stroke, so the air consumption for a single stroke is 4.51. For the return stroke, the volume of the piston rod must be reduced by 20mm diameter (0.0141/cm stroke × 50cm stroke = 0.71). Therefore, the air consumption for the return stroke is 3.8, and the air consumption for the round trip stroke is 8.3.

Figure 1-6

II. Cylinder Usage Requirements

(1) Normal working conditions of the cylinder: The medium and ambient temperature are generally -20~80℃, and the working pressure is generally 0.1~1.0MPa. For specific conditions, see the technical parameter table of various cylinders. (2) Before installation, a test should be conducted at 1.5 times the working pressure; there should be no air leakage.

(3) An oil mist lubricator should be installed at the air inlet to facilitate lubrication during operation. Proper lubrication of the cylinder is extremely important; poor lubrication often leads to crawling or even malfunction.

(4) During installation, pay attention to the direction of motion; the piston rod should not be subjected to eccentric or lateral loads.

(5) When the load changes during the stroke, a cylinder with sufficient output force should be used, and a buffer device should be added.

(6) Do not use the full stroke, especially when the piston rod is extended; do not allow the piston to collide with the cylinder head. Otherwise, damage to parts such as the piston and cylinder head can easily occur. EP grade stainless steel pipe, based on BA grade stainless steel, undergoes electrolytic polishing, resulting in a very bright inner and outer wall. It is suitable for industries such as medical devices, food and beverage piping, electronics, and high-purity gases.

Production Standards: GB (Chinese National Standard), ASTM (American Standard), JIS (Japanese Standard), DIN (German Standard)

Steel Pipe Material: 304, 304L, 316, 316L, 316Ti, etc.

Pipe Standards: Metric (ISO), Imperial (Inch), Japanese (A)

Pipe Classification: Pickled, mechanically polished, bright annealed, electrolytic polished. Processing Technology: Multiple cold rolling and cold drawing processes, internal and external sizing, bright annealing, and polishing.

Product Accuracy: Tolerance range below 0.2mm, inner wall roughness Ra≤0.05μm

Customization: 2m, 4m, 6m (all available)

Product Packaging: The product is cleaned with 60°C pure water and purified by purging with heated and filtered nitrogen gas. Both ends of the pipe are capped. Each tube is individually packaged in a double-layered anti-static bag and bulk-packaged in a cleanroom meeting ISO Class 4 cleanliness standards.

Applications: High-fluidity electronic instruments and equipment, as well as medical, chemical, and semiconductor instruments industries.